Essentra

Essentra HSR-1 Heat sink, drawn with spring FULLY compressed. Centroid for X,Y is at center of part. Z is at BOTTOM surface of lowest spring because that is what will contact with the heat sink. Can be brought into Altium with no need for any offset for X,Y, or Z.

Littelfuse

Part complies with mechanical dimensions of data sheet - http://www.littelfuse.com/~/media/automotive/datasheets/fuses/passenger-car-and-commercial-vehicle/blade-fuses/littelfuse_mini_datasheet.pdfPart also has all mechanical details that one would see looking at the actual fuse. Part renders nicely.

None

Generic 0805 Resistor that has the correct origins to allow you to drag and drop into Altium Designer and not have to change the X, Y or Z so that when you output to Step and into Circuit Works, you will not lose placement orientation.

Bourns

Bourns TC-33X2 Series Trim Pot

Texas Instruments

8 ball BGA for 555 timer etc.

Rohm

High power surface mount 8 pin device

Vishay

TO-277 (SMPC) power diode package

Ohmite

Heatsink TO-264. Spring clip is pre-bent to interface to front of TO-264 (spring clip is NOT in its relaxed state)

Keystone

Keystone #1291 9V Battery Holder PCB Through Hole

United Chemicon

33uF 50V Electrolytic SMT Capacitor 6.3mm Diameter 8mm Height