This metal Offset Servo Bracket bracket is used with the REV 15mm Extrusion System. This bracket allows you to mount standard size servos in line with other low-profile motion components.

This bracket is used to mount the REV HD Hex Motor and AndyMark Neverest motors to the 15mm REV Extrusion. It has a 90 degree bend on the mounting face.

This bracket is used to mount the REV HD Hex Motor and AndyMark Neverest motors to the 15mm REV Extrusion.

This metal Ball Bearing Mount bracket is used with the REV 15mm Extrusion System. Version 2 brackets offer many improvements over our previous metal brackets, including holes on an 8mm grid that is compatible with many other building systems.This bracket is used to mount 12mm OD bearings to the 15mm REV Extrusion.

This bracket can be used with the REV 15mm Extrusion System with a REV Robotics Bearing seated in the 9mm holes as a shaft support bracket and multiple axle motion. This bracket has alignment ribs on one side which are designed to seat the bracket into the extrusion channel increasing joint alignment, strength, and rigidity.

This indexable bracket is used with the REV 15mm Extrusion System to create an adjustable shaft support. Both brackets have a sawtooth pattern which fit together and can be adjusted in 1mm increment. The larger bracket in this set has a 9mm center hole surrounded by a ring of six M3 clearance holes to use with REV Robotics Plastic Bearings to support a shaft. The smaller bracket in this set has alignment ribs on one side which are designed to seat the bracket into the extrusion channel increasing joint alignment, strength, and rigidity.

This bracket can be used with the REV 15mm Extrusion System with a REV Robotics Bearing seated in the 9mm center hole as a shaft support bracket. This bracket has alignment ribs on one side which are designed to seat the bracket into the extrusion channel increasing joint alignment, strength, and rigidity.

This battery plate is the perfect size to support a REV 12v Battery, REV Control Hub, or REV Expansion Hub

Aluminum cubes that allow users to quickly create square assemblies using REV 15mm Extrusion.

This lap corner bracket is used with the REV 15mm Extrusion System. The opposite face of the bracket is flat to allow mating with different orientations of extrusion.